AMX RDM-2DC bruksanvisning

AMX RDM-2DC
(1)
  • Sidantal: 1
  • Filtyp: PDF

Installation Guide

RDM-2DC Dual DC Dimmer Module 1920W, 0-10 VDC (x2)

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
7/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-606-61 REV: A
The RDM-2DC Dual DC Module (FG606-61) is a 1920 W module used for the
dimming of fluorescent ballast loads. It uses a 0 to 10 VDC current sinking for use with four-wire ballasts. It is designed for use with the RDA series of enclosures, in an AMX Lighting™ modular digital dimming system. The module’s 120 and 277 VAC ratings are CE, UL, and C-UL approved.
RDM-2DC UL and C-UL Ratings
• 120 VAC, 50/60 Hz, 1920 W• 277 VAC, 50/60 Hz, 1920 W• Control Out: 50 mA, 12 VDC sinking
Suggested Dimmed Loads
• Four-wire dimmable ballasts, like Advance Transformer Mark VII™ or the Energy Savings SuperDim™ series
Specifications
• Dimensions (HW): 10" x 2.75" (25.4 cm x 6.99 cm)• Non-phase dependant• Use wires rated at 75°C (167°F)• Torque terminals to 20 in-lbs. (2.3 N/M)• Max. wire size: 10 AWG (4 mm²)• Wire stripping length: 0.28" (7 mm)• Weight: 2.6 lbs. (1.180 kg)• BTU/hr: 150• Control current: 125 mA @ 12 VDC per control port
Caution: Pre-Installation Notes
• All Class 1 wiring must be connected to proper terminals.• All control wiring must be connected to proper terminals.• Disconnect power while installing or connecting the unit.• Keep top and bottom air vents clear at all times.• Use low-voltage wires with a 300 volt rating or greater.• Use field installed copper conductors.• All electrical ratings are for continuous duty.• For indoor use only.• Test loads for shorts before connecting.• This module may require extra power from the AXlink connection or an external power supply connected to the control card.
Connecting the RDM-2DC to the AMX Lighting Master
Lighting Application DrawingsWarning: Failure to ground the ballast may cause ballast failure
FIG. 1 RDM-2DC
Low-voltage control
wiring: 4-pin
Relay
+ out (LV)
- out (LV)
Line in
Load out
High
Low-voltage
voltage
connector to AMX
Lighting master
controller
Mounting
points
+ out (LV)
- out (LV)
Line in
Load
High
Low
voltage
Relay
voltage
Fuses
out
FIG. 2
Connecting the RDM-2DC and AMX Lighting Master
FIG. 3 RDM-2DC application wiring
Pin 4 (GND)
Pin 3 (RLY)
Pin 2 (DIM)
Pin 1 (+12 V)
RDM-2DC 4-pin module connector
1 (+)
2 (DIM)
3 (-)
GND
4-pin plug from RDM series module
Note: The 4-pin plugs from the module connector to the 4-pinconnector on the master (black plug cover facing up).
Ballast
Florescent
Neutral
Line in (HOT)
Load
Neutral
+
-
Circuit breaker
panel
Ballast
The fuses protect the dimming
circuit from a low impedance load.
The fuse will blow if it were
incorrectly wired
Catastrophic ballast failure
Reversing switched and
dimmed circuits
Reversing dimmed and
line circuits.
The dimmed output must be
connected to a high impedance
load.
AMX RDM-2DC

Behöver du hjälp?

Antal frågor: 0

Behöver du hjälp eller har du en fråga om AMX RDM-2DC? Ställ din fråga här. Lämna en tydlig och omfattande beskrivning av ditt problem och din fråga. Ju mer information du anger desto enklare blir det för andra ägare av AMX RDM-2DC att svara på din fråga.

Se manualen för AMX RDM-2DC helt gratis här nedan. Den här manualen tillhör kategorin och har betygsatts av 1 personer med ett genomsnitt på 8.4. Den här manualen är tillgänglig på följande språk: Engelsk. Behöver du hjälp eller har du en fråga om AMX RDM-2DC? Ställ din fråga här

AMX RDM-2DC – specifikationer

Allmänt
Varumärke AMX
Modell RDM-2DC
Produkt Dimmer
EAN 718878009482, 7188780094822
Språk Engelsk
Filtyp PDF
Prestanda
Modell Dimmer
Design
inbyggd / fritstående Monterbar
Kontrolltyp Ej tillgänglig
Produktens färg -
Vikt & dimension
Bredd 69.9 mm
Höjd 254 mm
Vikt 1040 g
visa mer

Vanliga frågor

Nedan hittar du de vanligaste frågorna om AMX RDM-2DC .

Är din fråga inte listad? Ställ din fråga här