The ON/OFF and lighting modes are selected using a switch.
Switch operationStandard operating time
ON
↔
OFF: Long press
Hi
↔
Low: Single press
Flash: Quick double press
(Flash even from OFF)
Hi : Approx. 1.5 hours
Low : Approx. 3 hours
Flash : Approx. 12 hours
Wind the bracket strap around the handle-
1
bar, and put the strap through the opening.
Screw the dial into the bracket to secure it
2
temporarily.
Insert the light unit to the bracket until *
it clicks, and adjust the beam angle.
(Refer to “HOW TO MOUNT THE
LIGHT”)
Securely tighten the dial, and cut off any
3
excess bracket strap.
To remove the light unit, pull out it forward *
while pressing the button.
To re-adjust the beam angle, loosen the
*
dial enough to move the bracket, and
securely tighten it after adjustment.
CAUTION!:
Be sure to tighten the dial by hand. When •
you tighten it too hard with a tool, the
screw thread may be stripped.
Check the dial and screw (*1) on the •
bracket periodically, and use them with-
out any loosening.
Round off the cut edge of the bracket •
strap to prevent injury.
HOW TO CHARGEHOW TO MOUNTHOW TO USEHOW TO REPLACE THE BATTERY
When the operating time decreases signifi cantly, the battery life is close to an end. Please contact
CatEye local distributor listed on our website www.cateye.com or CatEye for replacing battery.
CAUTION!: The light unit is a precision device. Never disassemble it.
SPECIFICATIONS
Light sourceHigh-intensity white LED x 1
BatteryLi-ion 3.7v 1110mAH
ChargeMini USB plug
Operating time
Hi : Approx. 1.5 hours
Low : Approx. 3 hours
Flash : Approx. 12 hours
Standard charging time
Approx. 3.5 hours (USB2.0)
Temperature range
Charging : 41˚F – 104˚F (5˚C – 40˚C)
Operating : 14˚F – 104˚F (-10˚C – 40˚C)
Recharge/discharge number of timesAbout 300 times (until the rated capacity drops to 70%)
Dimensions/weight
3-25/64” x 1-31/32” x 1-17/64” (86 x 50 x 32 mm) / 2.8 oz (80 g)
(Including rechargeable batteries supplied)
The specifi cations and design are subject to change without notice.*
DISPOSE BATTERY
3
1
2
1
USB cable
To PC or USB
battery charger
Charge jack cover
Dial
Rubber pad
Bracket
Strap
Release
button
HOW TO MOUNT THE LIGHT
Screw
Switch
(indicator)
Battery
Battery
1
2
3
2-8-25, Kuwazu, Higashi Sumiyoshi-ku,
Osaka 546-0041 Japan
Attn: CATEYE Customer Service Section
Phone : (06)6719-6863
Fax : (06)6719-6033
E-mail : support@cateye.co.jp
URL : http://www.cateye.com
[For US Customers]
CATEYE AMERICA, INC.
2825 Wilderness Place Suite 1200,
Boulder CO80301-5494 USA
Phone : 303.443.4595
Toll Free : 800.5CATEYE
Fax : 303.473.0006
E-mail : service@cateye.com
CO
.,LTD.
Before using the light, please read this manual and the attached “Lithium-ion Bat-
teries” thoroughly, and keep them for future reference.
LIMITED WARRANTY
2-year Warranty: Light unit only (Deterioration of the battery is excluded.)
CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from
original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no
charge. Service must be performed by CatEye or an authorized retailer. To return the product, pack it carefully and
enclose the warranty certifi cate (proof of purchase) with instruction for repair. Please write or type your name and
address clearly on the warranty certifi cate. Insurance, handling and transportation charges to CatEye shall be borne
by person desiring service. For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase.
This does not affect your statutory rights.
Please register your CatEye product on the website.
http://www.cateye.com/en/support/regist/
CAUTION!
Before your trip, please make sure the light is fi rmly mounted to the bracket, it •
lights up, and the light is not blocked by baggage, etc.
Do not place it within children’s reach.•
In preparation for unexpected battery shutoff, we recommend you carry a spare light.
•
Mount the light unit more than 7 cm away from the wireless meter. When it is •
mounted too close, the transmission may be affected adversely.
This product is water-resistant under normal daily use and can be used in the •
rain. However, do not intentionally submerge it in water.
If the light unit or parts become dirty with mud, etc., clean with a soft cloth •
which is moistened with mild soap. Never apply paint thinner, benzine or alco-
hol; damage will result.
Remove the used battery and bring it with the connector covered with an insula-•
tion tape to the store supporting rechargeable battery recycling.
Before Initial Use
This unit is shipped with a small charge to check the light. Be sure to charge it be-
fore use, according to the instructions “HOW TO CHARGE”.
Light unit
FlexTight™ bracket
(H-34N)
USB cable
*2 When returning from ON to OFF, or Flash to ON (Hi or Low), it returns to the light-
ing mode used previously.
Remaining battery capacity
When the switch (indicator) lights up, the remaining battery level is low. Please
charge as soon as possible.
Anvisning
Se manualen för Cateye Nano Shot helt gratis här nedan. Den här manualen tillhör kategorin och har betygsatts av 1 personer med ett genomsnitt på 6.6. Den här manualen är tillgänglig på följande språk: Engelsk. Behöver du hjälp eller har du en fråga om Cateye Nano Shot? Ställ din fråga här
Behöver du hjälp?
Har du en fråga om Cateye Nano Shot som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Cateye Nano Shot-ägare att ge dig ett bra svar.
Antal frågor: 0
Cateye Nano Shot – specifikationer
Nedan hittar du produkt- och manualspecifikationerna för Cateye Nano Shot.
Behöver du hjälp?
Har du en fråga om Cateye Nano Shot som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Cateye Nano Shot-ägare att ge dig ett bra svar.
Antal frågor: 0