Cateye Strada RD300 bruksanvisning

Cateye Strada RD300
7.7 · 1
PDF anvisning
 · 2 sidor
anvisningCateye Strada RD300
Parts kit
Speed sensor
Wheel magnet
Bracket band
Lithium battery (CR2032)
Optional parts
Bracket holder
Standard parts
Wheel selection ..... Toggle between the specified wheel size (tire circumference)
and . Use this function if the computer is to be sharedbetween two bicycles.
................................ Pressing MODE toggles between and .
Wheel size entry .... Pressing MODE increases the value, and pressing and
holding MODE moves to the next digit.* To enter the wheel size
, display using Wheel selection.
Clock setting .......... To set the clock, refer to Preparing the computer-4.
Total distance manual entry................................ Before reinitializing the computer, note the total distance. Thisreading will later allow you to enter the total distancemanually. Pressing MODE increases the value, and pressingand holding MODE moves to the next digit.
Speed unit .............. Pressing MODE toggles between
and .
To clean the computer or accessories, use diluted neutral detergent on a soft cloth, andwipe it off with a dry cloth.
Replacing the battery
ComputerIf the display appears faded, replace the battery.Install a new lithium battery (CR2032) with the (+)side facing upward. Then reinitialize the computer
referring to Preparing the computer.
* When the battery is installed, place the inner sealcap with the TOP side upward.SensorIf sensor reception is poor, replace the battery.After replacement, check the positions of the sensor and magnet.
2-Year Computer only
(Accessories/Bracket sensor and Battery Consumption excluded)
CatEye cycle computers are warranted to be free of defects from materials and workmanship for a period of two years
from original purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no
charge. Service must be performed by CatEye or an authorized retailer.
To return the product, pack it carefully and enclose the warranty certificate (proof or purchase) with instruction for
repair. Please write or type your name and address clearly on the warranty certificate.
Insurance, handling and transportation charges to CatEye shall be borne by person desiring service.
For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan
Attn: CATEYE Customer Service
Phone : (06)6719-6863
Fax : (06)6719-6033
E-mail :
[For US Customers]
2825 Wilderness Place Suite 1200, Boulder CO80301-5494 USA
Phone : 303.443.4595
Toll Free : 800.5CATEYE
Fax : 303.473.0006
E-mail :
MODE does not work when the computer is mounted on its bracket.
Check that there is no dirt between the bracket and the computer.
Wash off the bracket with water to get rid of any dirt, and to ensure that the computer slides in and out smoothly.
The sensor signal reception icon does not flash. (The speed is not displayed.)
(Spin the front wheel, bringing the computer closer to the sensor. If the icon now flashes, this indicates that the
computer and sensor are too far apart or that the battery is low.)
Is the clearance between the sensor and magnet too great? (must be
5 mm)Does the magnet pass through the sensor zone?
Adjust the positions of the magnet and sensor.
Is the computer installed at the correct angle?
Back of computer must face toward the sensor.
Are the computer and sensor too far apart? (The distance must not exceed 70 cm.)
Install the sensor closer to the computer.
Is the computer or sensor battery weak?
In winter, battery performance diminishes.
Replace the battery. In the case of the computer, after replacing the battery, re-start the computer according to the
Preparing the computer, above.
No display.
Is battery in the computer run down?
Replace it. Then reinitialize the computer referring to Preparing the computer.
Incorrect data appear.
Reinitialize the computer referring to Preparing the computer.
Battery ................. Computer : Lithium battery (CR2032) x 1
Sensor : Lithium battery (CR2032) x 1
Battery life ........... Computer : Approx. 1 years (If the computer is used for 1 hour/day; the battery life will vary
depending on the conditions of use.)
Sensor : Unit Total Distance reaches about 10,000 km (6,250 mile)
* This is the average figure of being used under 20 °C temperature and the distance between the computer and the
sensor is 65 cm.
Controller .................................. 4-bite, 1-chip microcomputer (Crystal controlled oscillator)
Display ...................................... Liquid crystal display
Sensor ...................................... No contact magnetic sensor
Wheel circumference range ..... 0100 mm - 3999 mm (Default figure A: 2096 mm, B: 2096 mm)
Working temperature ............... 32 °F - 104 °F (0 °C - 40 °C) (This product will not display appropriately when exceeding the
Working Temperature range. Slow response or black LCD at lower or higher temperature
may happen respectively.)
Dimensions/weight ................... 1-53/64 x 1-7/32 x 5/8 (46.5 x 31 x 16 mm) / 0.78 oz (22 g)
* The factory-loaded battery life might be shorter than the above-mentioned specification.
* The specifications and design are subject to change without notice.


Pace arrow
Indicates whether the current speed
is faster ( ) or slower ( ) than the
average speed.
Operating the computer [Measuring screen]

Tm Elapsed Time

0:0000 - 9:5959

Dst Trip Distance

0.00 - 999.99 km [mile]

Trip Distance-2

0.00 - 999.99 /1000.0 - 9999.9 km [mile]

Av Average Speed

0.0 - 105.9 km/h[0.0 - 65.9 mph]

Mx Maximum Speed

0.0(4.0) - 105.9 km/h[0.0(3.0) - 65.9 mph]

Odo Total Distance

0.0 - 9999.9 /10000 - 99999 km [mile] Clock0:00 - 23:59or 1:00 - 12:59
*1 With the computer installed on the bracket, press
on the three raised dots on the face of the
*2 If Tm exceeds approximately 27 hours or DST
exceeds 999.99 km, .E (Error) is displayed as
the average speed. Reset data.
Settingchange (bypressing &holding)Current speed
0.0(4.0) - 105.9 km
[0.0(3.0) - 65.9 mph]
Changing the computer settings [menu screen]
If the MENU is pressed with the measuring screen displayed, the menu screen
appears. Press the MODE when measurement has stopped and no signal isbeing received to change menu settings.Starting/Stopping measurement
Measurements occur automatically when
the bicycle is in use. During
measurement, or flashes.
Switching computer function
Pressing MODE switches function, in
order, as shown on the left.
Resetting data
To reset measurement data, display any
data other than for Dst-2 and then press and
hold MODE. Pressing and holding MODE
with Dst-2 displayed resets Dst-2 only.
The total distance is never reset.
Power-saving function
If the computer has not received a signal
for 10 minutes, power-saving mode will
activate and only the clock will be
displayed. When the computer receives a
sensor signal again, the measuring screen
reappears. If two weeks inactivity elapses,
power-saving mode will change to SLEEP
mode. Pressing the MODE in SLEEP mode
brings up the measuring screen.
Selected Mode
WheelselectionWheel sizeentryClock setting Total distancemanual entrySpeed unit* After changing, be sure to press MENU to register thesetting.* If the menu screen is not touched for a minute, theMeasuring screen reappears without data changes.
CR2032Inner Seal


Se manualen för Cateye Strada RD300 helt gratis här nedan. Den här manualen tillhör kategorin och har betygsatts av 1 personer med ett genomsnitt på 7.7. Den här manualen är tillgänglig på följande språk: Engelsk. Behöver du hjälp eller har du en fråga om Cateye Strada RD300? Ställ din fråga här

Behöver du hjälp?

Har du en fråga om Cateye som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Samsung Galaxy A7-ägare att ge dig ett bra svar.

Antal frågor: 0

Cateye Strada RD300 – specifikationer

Nedan hittar du produkt- och manualspecifikationerna för Cateye Strada RD300.

Varumärke Cateye
Modell Strada RD300
Produkt Cykeldator
EAN 4990173017577, 4990173021000
Språk Engelsk
Filtyp PDF

Vanliga frågor

Hittar du inte svaret på din fråga i manualen? Svaret kan finnas här nedan i vanliga frågor gällande Cateye Strada RD300.

Är din fråga inte listad? Ställ din fråga här

Inga resultat