Three, G F our and G Five are two
y active loudspeak ers designed to produce
broad bandwidth sound with high output and
ositioning the loudspeaker
r is supplied with a built-in
ampliﬁer unit, mains cable and an operating
After unpacking, place the loudspeak -
ers in their required listening positions, point
ing them to the center of the listening area.
, place the listening position along the
middle axis of the room and the loudspeakers
at equal distance from the side walls.
Before connecting up
, ensure that the power
switches on the loudspeak
ers and the signal
source are set to OFF
. The po wer switch
is located on the back panel of the loud
. Do not connect the loudspeaker to an
thed mains supply or using an unear thed
Audio input is via a 10 kOhm balanced f
XLR connector or unbalanced RCA connector
Only line lev
el audio signal from a preampliﬁer ,
computer sound card or similar signal source
can be connected, ne
ver a high po wer signal
from the speaker terminals of a power ampliﬁer
It is possible to connect two audio sources to
the loudspeakers at the same time using both
connectors, as long as only one source is used
at a time.
Once the connections ha
ve been made, the
loudspeakers are ready to be s
utostar t function
Three, G F our and G Five a ha ve a
witch on the back panel. Set this s witch
when the loudspeakers are left unused
veral da ys or when connecting or discon -
necting any cab
les in the system.
When the switch is set to
“ON”, the signal
sensing Autostart function of the loudspeakers
powers them up when pla
yback begins. Auto -
matic powering down of the loudspeak
ers hap -
pens one hour after the playbac
k has ended
and the loudspeakers go to standb
y mode. The
nsumption in standby mode is less
than 0.5 watts.
The loudspeaker will automati -
cally and rapidly start once an input signal is
detected from the source.
Setting the pla
yback le vel
k lev el of theloudspeakers has tw o
basic settings, normal and +10 dB.
The nor mal
setting is factory default and the +10 dB setting
can be selected by turning the “LEVEL +10 dB”
the back panel to “1”. This makes the
y louder , which is useful if the
el is low .
Switching off the pow
The power indicator LED can be s
by turning the
“LED OFF” switch on the bac k
panel to “1”.
Setting the tone controls
The frequency response of Genelec G
G Four and G Fiv
e can be adjusted to match
the acoustic environment b
y setting the tone
control switches on the rear panel.
abletop”, “T reb le”, “Bass” and “Low Bass”.