Horstmann ChannelPlus H21XL bruksanvisning

Horstmann ChannelPlus H21XL
7.5 · 1
PDF anvisning
 · 2 sidor
Engelsk
anvisningHorstmann ChannelPlus H21XL

BATTERY

The programmer is fitted with a non-rechargeable, long life battery, which will maintain the

programmed time settings for a minimum of ten months with the supply disconnected.

THIS SHOULD BE SUFFICIENT TO COVER POWER INTERRUPTIONS DURING THE LIFE OF THE UNIT.
During power interruptions the display will be blank, after 3 days the current time of day will be lost.
If the programmer is not to be used for a long period of time, the switch on the rear of the unit
should be returned to the BATTERYOFF position. These are both to prolong the battery life.

SERVICE AND REPAIR

This programmer is NOT user serviceable. Please do not dismantle the unit.

In the unlikely event of a fault developing please refer to the RESETTINGTHEPROGRAMMERsection of
this user guide located on page 2. If this fails to resolve the problem please contact a local heating

engineer or a qualified electrician.

QUESTIONSANDANSWERS
The display only reads bAt
The unit display has become frozen
The indicator neon fails to illuminate on
Hot Water or Central Heating channel
The indicator neon will illuminate but
the pump and/or boiler fails to
operate
There is no display on the
programmer
How do I know if the programmer is
still under warranty
How is the programmer removed from
the wall
When setting the programme times, the
setting ‘bounces’ by 10 minute periods
Turn the battery on.The switch on the rear of the unit must be in either the Fully Pumped
or Gravity position.
This could be due to local electrical interference
Using the RESET procedure may rectify the fault.
Using the RESET procedure may rectify the fault. If the problem persists the
programmer will need replacing.
This may indicate a problem elsewhere in your system;
E.g. A zone valve, etc. please contact a registered installer for advice.
Try the RESET procedure on page 2, if this fails to rectify the problem please have the
mains supply checked
The ChannelPlus XL range comes with a 5 year guarantee from the date of manufacture.
This date is located on the rear of the unit, indicated by a month over a year
WARNING: The ChannelPlus programmer must only be removed from it’s backplate by
either a qualified electrician or heating engineer; The programmer plugs in to a 9 pin
backplate located on the rear of the unit and is secured using 2 screws located on the
top surface of the unit. Undo these screws and pull forward and down in an arc motion
This indicates that you have reached an existing set time period, you will be unable to
set a new ON/OFF time unless there is an alteration to the existing timed period
LEAFLET No P32635
ISSUE 3
Page 1
Page 4

The following are some of the easy to operate features:-

1 or 2 Hour Boost on each channel

Advance control gives instant On/Off override

Independent timing on Hot Water and Heating

Up to 3 On/Off periods per channel in each 24 Hour operation

Programme options: Auto / All day / On constantly / Off

FULLY PUMPED OR GRAVITY SYSTEM

The installer will have set the programmer to suit the installed system. If this is a Fully pumped
system this will allow independent control of the Central heating and Hot water, however on a Gravity
system the Central heating and Hot water are linked so that it is not possible to use the Central
heating independently. This will allow only one common time setting for both Hot Water and Central

Heating.

Horstmann’s ChannelPlus H21XL - Two Channel Programmer Offers up

to three programmed operating periods per day with independent

Boost and Advance control on Fully Pumped Systems.

Can be used as a direct replacement for Horstmann 425 Diadem, Tiara

and H525(Allowing for new programmer position).

1
5
4
3
2
7
6
8
9

11

10

13

12

14

LCD DISPLAYFEATURES
1 Current TIME OF DAY
2 Switch time SETTING indicator
3 ADVANCE symbol
4 BOOST symbol
5 Current Hot water programme
6 Current Central heating programme
7 Next Central heating switch time
8 Next Hot water switch time
15 SET slider switch
16 SET Positions

Internal Slide Switch -

located under front cover

16

15

LED INDICATOR
9 Central heating ON indicator
10 Hot water ONindicator
EASY TOUSE PROGRAMMEANDFEATUREBUTTONS
11 Central heating ADVANCE(ENTER) button
12 Hot water ADVANCE (PLUS) button
13 Central heating BOOST button
14 Hot water BOOST (MINUS)button
Both the Central heating and Hot water SELECT
buttons are located under the front cover

Horstmann Controls Limited

Bristol

BS4 1UP

Email: sales@horstmann.co.uk
Website: www.horstmann.co.uk

Anvisning

Se manualen för Horstmann ChannelPlus H21XL helt gratis här nedan. Den här manualen tillhör kategorin och har betygsatts av 1 personer med ett genomsnitt på 7.5. Den här manualen är tillgänglig på följande språk: Engelsk. Behöver du hjälp eller har du en fråga om Horstmann ChannelPlus H21XL? Ställ din fråga här

Behöver du hjälp?

Har du en fråga om Horstmann ChannelPlus H21XL som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Horstmann ChannelPlus H21XL-ägare att ge dig ett bra svar.

Antal frågor: 0

Horstmann ChannelPlus H21XL – specifikationer

Nedan hittar du produkt- och manualspecifikationerna för Horstmann ChannelPlus H21XL.

Allmänt
Varumärke Horstmann
Modell ChannelPlus H21XL
Produkt Termostat
Språk Engelsk
Filtyp Användarmanual (PDF)

Vanliga frågor

Hittar du inte svaret på din fråga i manualen? Svaret kan finnas här nedan i vanliga frågor gällande Horstmann ChannelPlus H21XL.

Är din fråga inte listad? Ställ din fråga här

Inga resultat