’ s Manual
A NT : Read all of the in structions before
attempting to install the SSL-SMOKE detector
The SSL-SMOKE detector is a device, which connects with
SSL-EMD. When smoke is detected
an alarm will sound
alerting the users. Through the SNMP-SSL card, the user can
monitor it and receive notif
ic ations of the alarms.
smoke detec tor can be powered by 120 V AC utility
a 9-volt battery
. AC/DC smoke detectors offer added
protection in the event of a power failure or a dead battery
A LLA TION
1. Detach the cover by twisting
it until it unlatches from the
smoke detector base.
2. Using the smoke detector bas
e as pattern, trace outlines o
the two key
hole slots ont o the mounting surface.
3. Drill a pilot hole in the cente
r of the small end of each of the
keyhole slots in the mounting surface.
4. Insert and tighten the mounting screws in the pilot holes
leaving approximately 1/8”
of the screw s sticking out.
5. Mount the smoke detector base making sure that scre
are positioned in the sm
all en ds of the keyholes and tighte n
6. Snap on the battery wire clip and insert the battery into
7. Replace the cover by twisting it until it latches. T
detector is now operating.
est the smoke detector by pushing test button on cov e
and holding the button down for about 2-seconds.
Use the following steps to set-up and connect the
SSL-SMOKE detector to the SSL-EMD:
1. Loosen the screws on SSL-EMD.
2. Connect the wires from the SSL-SMOKE detector to the
Alarm-1 and/or Alarm-2, and then tighten the screws.
3. Connect the straight-through
CA T5 network cable from the
card’s RJ45 connector l abeled “COM” to the
connector labeled “010101” on the SSL-EMD.
erify that the SNMP-SSL card has a network connection and
is powered on.
5. Check the LED (Power/S
tatus) of SSL-EMD, it will flash ever
6. Open a Web brow
ser and connect to the SNMP-SSL card.
7. Change the setting of “SSL-EMD St
atus” from “Disa ble” to
“Auto” on the EMD C
8. Set the status of
Alarm-1 and/or Alarm-2 to “Normal Open”.
9. The installation of the SSL-SMOKE detector is complete. See
User ’s Manual.
The SSL-SMOKE detector operates w ith 120V AC or a
. Connecting to the 120V AC utility power is not
required to operate the detector
. Ho w e ver , operating with both
the utility power and the batt
ery of fers added protection in the
event of a power failure or a dead battery
LIMITED PRODUCT W
Para Systems Inc. (Para Systems) warrants this equipment, when
properly applied and operated
within specified conditions, against
faulty materials or workmanship fo
r a period of three years from the
date of original purchase by the end user
. For equipment sites within
the United S
tates and Canada, this warranty covers repair o
replacement of defective equipment at the discretion of Para Systems.
Repair will be from the near
est author ized service center.
Replacement parts and warranty labor will be borne by Para Systems.
For equipment located outside of the United S
tates and Canada, Para
Systems only covers faulty part
s. Para Sy stems product s repaired o
replaced pursuant to this warranty shall be
warranted for the remaining
portion of the warranty that applies to the original product. This
warranty applies onl
y to the original purchaser who must have properl
registered the product within 10 days of purchase.
The warranty shall be void if (a) the equipment i
s damaged by the
, is improperly used, is subjected to an adverse operating
environment, or is operated outside the limit
s of its electrical
specifications; (b) the equipment is
repaired or modified by anyone
other than Para Systems or Para Systems-approved personnel; or (c)
has been used in a manner contrary to the pro
duct's operating manual
or other written instructions.
ny technical advice furnished before or after delivery in regard to use
or application of Para Systems’s equipment is furnished without charge
and on the basis that it represents Para Sy
ste ms’ s best judgment
under the circumstances, but it is used at the recipient's sole risk.
EXCEPT AS PROVIDED HEREIN, P
ARA SYSTEMS M A KES NO
ARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
ARRANTIES OF MERCHANT ABILITY AND FITNESS FOR
ARTICULAR PURPOSE. Som e st ates do not permit limit ation o
implied warranties; therefore, the aforesaid limitation(s) may not apply
to the purchaser
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL P
SYSTEMS BE LIABLE FOR DIRECT
, INDIRECT , SPECIAL,
AL, OR CONSEQUENTIAL DAMAGES ARISING OUT OF
THE USE OF THIS PRODUCT
, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE.
S pecifically , Para Systems is not
liable for any costs, such as lost profit
s or revenue, loss of equipment,
loss of use of equipment, loss of software, loss of data, cost o
substitutes, claims by third parties, or otherwise. The sole and
exclusive remedy for breach of an
y warranty , expressed or implied,
concerning Para Systems’s product
s and the only obligation of Para
, shall be the repair or replacement of defective
equipment, components, or parts; or
, at Para Systems’s option, refund
of the purchase price or substitution with an equivalent replacement
warranty gives you specific legal rights and you may
also have other rights, which vary
from state to state.
A INING TECHNICAL ASSIST ANCE
Para Systems (Minuteman UPS) T
.minutemanups.com © Copyright 2008 34000363 R1