1. Choose an appropriate corner location. The WS6 can be
mounted at any height in a corner.
2. Complete all wire and conduit runs prior to installation of
the housing.
REVISION DATE: 11-11-2010
Depending on the voltage being used, refer to one of the formulas
below to select the correct power supply for cameras connected
in parallel (positive to positive, negative to negative):
Total current for a 12 VDC system:
TOTAL CURRENT = (350mA x total number of cameras)
Total current for a 24 VAC system:
TOTAL CURRENT = (202mA x total number of cameras)
VOLTAGE CURRENT POWER
12 VDC 350mA 4.2W
24 VAC 202mA 4.8W
CABLE AND POWER GUIDELINES
(Detailed info on Page 11)
This chart shows the proper current needed for power supplies for
Warrior Series cameras. Use Class 2 Power only. Input voltage
must be between 12-28 VDC or 15-28 VAC.
81-IN5219 WARRIOR 6
WS6
INSTALLATION PROCEDURE
1. Using the security tool provided, loosen the (3) 10-32 security
fasteners and remove the face plate (Figure 1).
4. Feed the wiring through the conduit knockout. A clamp
connector is included should you desire to use it. Install
the connector so that the nut is on the outside of the housing.
Be sure the hole in the wall is large enough to accommodate
the nut. Tighten the nut securely, making sure that the screw
heads on the connector are in an easy to reach position,
then feed the wiring through the clamp connector.
5. Mount the back box to the wall using appropriate hardware
(not provided).
NOTE: If the clamp connector was used, tighten the screws
at this time. Make sure enough wire is inside
the back box to complete the wiring process.
2. Place the back box into position and mark the four mounting
holes (Figure 2).
3. If you're using the top conduit knockout (Figure 2) REMOVE
THE CAMERA AND BRACKET TO PREVENT DAMAGE.
If using one of the side conduit knockouts it's not necessary to
remove the camera and bracket; however, use caution.
Mounting
Holes
Figure 1
Top conduit knockout behind camera CAMERA MUST BE
REMOVED BEFORE USING
Mounting Holes
Figure 2
TABLE OF CONTENTS
Cable and Power Guidelines 1, 11
Installation Preparation 1
Installation Procedure 1
Wiring 2
Optional Warrior Test Monitor Cable 2
Camera Bracket Setup 2
Camera Focusing 3
Camera Settings 3
Completion of Installation 5
Window Guard™ Replacement 5
NVT Instructions 5
Warranty Information 7
Service and Safeguard Information 8
Troubleshooting 9
Se manualen för Moog Videolarm WS6S-50NF-X2 helt gratis här nedan. Den här manualen tillhör kategorin och har betygsatts av 1 personer med ett genomsnitt på 5.1. Den här manualen är tillgänglig på följande språk: Engelsk. Behöver du hjälp eller har du en fråga om Moog Videolarm WS6S-50NF-X2? Ställ din fråga här
Behöver du hjälp?
Har du en fråga om Moog Videolarm som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Moog Videolarm -ägare att ge dig ett bra svar.
Hittar du inte svaret på din fråga i manualen? Svaret kan finnas här nedan i vanliga frågor gällande Moog Videolarm WS6S-50NF-X2.
Vad är en megapixel?
Antalet megapixlar anger hur många pixlar det finns i sensorn. 1 megapixel motsvarar 1 miljon pixlar. Ju fler pixlar, desto högre är den potentiella bildkvaliteten.
Vad står förkortningen 'MP' för?
MP står för MegaPixels.
Vilka certifieringar har Moog Videolarm WS6S-50NF-X2?
Moog Videolarm WS6S-50NF-X2 har följande certifieringar: WEEE, UL, CUL.
Vad är höjden på Moog Videolarm WS6S-50NF-X2?
Moog Videolarm WS6S-50NF-X2 har en höjd på 77.6 mm.
Vad är bredden på Moog Videolarm WS6S-50NF-X2?
Moog Videolarm WS6S-50NF-X2 har en bredd på 165.1 mm.
Vad är djupet på Moog Videolarm WS6S-50NF-X2?
Moog Videolarm WS6S-50NF-X2 har ett djup på 127 mm.
Är manualen för Moog Videolarm WS6S-50NF-X2 tillgänglig påSvenska?
Tyvärr är manualen för Moog Videolarm WS6S-50NF-X2 inte tillgänglig på Svenska. Denna manual finns på Engelsk.
Behöver du hjälp?
Har du en fråga om Moog Videolarm som inte besvarats i manualen? Ställ din fråga här. Ge en heltäckande beskrivning av problemet och formulera din fråga så tydligt som möjligt. Ju tydligare problemet beskrivs och frågan ställs, desto enklare är det för andra Moog Videolarm -ägare att ge dig ett bra svar.
Antal frågor: 0